«Payment by installments» of monobank
payments
of $0.67
No commission. The customer`s billing phone number must match the monobank customer`s financial number
Gear for meat grinder Uni G-017
The gear for the meat grinder Uni G-017 is designed to ensure the efficient operation of your kitchen appliance. This part is crucial for transferring rotational motion from the motor to the blades of the meat grinder, allowing for quick and high-quality processing of meat and other products. If the gear is damaged or worn, it can lead to reduced performance of the meat grinder or a complete halt in its operation.
Technical specifications
| Parameter | Value |
|---|---|
| Major diameter | 47 mm |
| Minor diameter | 17.5 mm |
| Number of teeth on the larger side | 54 |
| Number of teeth on the smaller side | 16 |
Compatibility
The gear is compatible with the meat grinder Uni G-017. Make sure you have this specific model before making a purchase. Check the original gear for identification marks to avoid mistakes.
How to choose the right part
To select the correct gear for your meat grinder, pay attention to the following points:
- Your meat grinder model - ensure that the gear is specifically for Uni G-017.
- Gear dimensions - compare the diameters and number of teeth with the original part.
- Material quality - choose parts from reputable manufacturers to ensure durability.
Possible causes of failure and prevention methods
The gear may fail for several reasons:
- Tooth wear - can occur due to prolonged use or overloads.
- Improper installation - can lead to damage and reduced performance.
- Insufficient lubrication - can accelerate the wear of the part.
To prevent failures:
- Regularly check the condition of the gear and other parts of the meat grinder.
- Follow load recommendations, and do not overload the device.
- Use lubricants as needed.
Difficulty of part replacement
Replacing the gear in the meat grinder Uni G-017 is of medium difficulty and can be done independently with minimal tools. Follow these steps:
- Disconnect the meat grinder from the power supply.
- Remove the cover to access the internal mechanisms.
- Remove the old gear by carefully freeing it from its mounts.
- Install the new gear in place of the old one, following the installation instructions.
- Reassemble the meat grinder and conduct testing.
If you lack experience in appliance repair, it is recommended to consult a professional.
