«Payment by installments» of monobank
payments
of $2.33
No commission. The customer`s billing phone number must match the monobank customer`s financial number
Switch for oven and electric stove Argeson AC8.805A
The Argeson AC8.805A switch is designed to control the operating modes of your oven and electric stove. With this switch, you can easily toggle between 9 modes and the "0" position. This switch is an essential component that ensures the proper functioning of your appliance.
Technical specifications
| Parameter | Value |
|---|---|
| Number of positions | 9+1 (modes + "0" position) |
| Shaft | Ø 4.5 x 6 mm, length 23 mm |
| Connection | 6.3 mm terminals |
| Mounting | 2 M4 threaded holes (center-to-center distance 28 mm) |
| Body dimensions (block) | 73 x 49 x 29 mm |
How to choose the right switch
When selecting the Argeson AC8.805A switch, it is important to pay attention to the following parameters:
- Number of positions: Ensure that your old switch has a similar number of modes.
- Shaft size: Check the diameter and length of the shaft to ensure compatibility with your device.
- Mounting: Make sure the distance between the mounting holes matches your device.
- Body dimensions: Verify the dimensions to ensure the switch fits in the designated space.
Causes of failure and prevention methods
Switches can fail for several reasons:
- Wear of the switching mechanism due to frequent use.
- Contact groups may oxidize, leading to poor connections.
- Moisture can enter the device and cause corrosion.
To prevent rapid wear of the switch, follow these recommendations:
- Avoid abrupt switching between modes.
- Ensure a dry location for the installation and operation of the device.
- Regularly check and clean the switch from dirt.
Difficulty of switch replacement
Replacing the Argeson AC8.805A switch is of medium difficulty and can be done independently with basic electronics skills. Here is a general outline of the steps:
- Disconnect the device from the power supply.
- Remove the old switch by disconnecting the wires from the terminals.
- Install the new switch in place of the old one, securing it with the mounting hardware.
- Connect the wires to the new terminals, following the wiring diagram.
- Test the switch by plugging the device back in.
By following all recommendations, the switch replacement will not take much time and will not require special tools.
