Coolflex rubber thermal insulation, R-Flex 10*6mm, 2m

SKU: т100062182

Coolflex rubber insulation, R-Flex 10*6mm, 2m

Coolflex rubber insulation, R-Flex is a high-quality insulating material designed to protect pipelines and equipment from heat loss. This product is ideal for use in heating, ventilation, and air conditioning systems, as well as in refrigeration units. It can significantly enhance energy efficiency and reduce operating costs.

Technical specifications

Specification	Value
Length	2 m
Wall thickness	6 mm
Hole diameter	10 mm (±1 mm)
Operating temperature	From -40°C to +120°C
Density	45-60 kg/m³
Thermal conductivity coefficient	0.032 W/(m·K)
Oil and gasoline resistance	Good
Biological resistance	Good
Flammability	B S3 D0 (Class 0)
Material	Foamed synthetic rubber
Manufacturer	K-Flex (Italy)/NMC (Belgium)/ODE (Turkey)

How to choose the right product

When selecting insulation, it is important to pay attention to the following parameters:

Diameter and thickness: Ensure that the diameter and thickness are suitable for your pipeline or equipment.
Temperature range: Check that the material can withstand temperatures appropriate for your operating conditions.
Density: The choice of density depends on the area of application and the required thermal insulation properties.

It is also recommended to review certificates and safety standards to ensure the quality and reliability of the material.

Possible causes of failure and prevention methods

The main causes of insulation damage may include:

Exposure to high temperatures exceeding the specified range.
Mechanical damage during installation or operation.
Influence of chemicals if the material lacks sufficient resistance.

To prevent wear, it is recommended to:

Properly install the insulation, avoiding bends and damage.
Regularly check the condition of the insulation and replace damaged sections as needed.
Avoid contact with aggressive chemicals.

Difficulty of part replacement

Replacing Coolflex, R-Flex insulation does not require special skills and can be done independently. The process includes the following steps:

Disconnect the equipment or pipeline that needs to be insulated.
Remove the old insulation by carefully cutting it away.
Prepare the surface: clean it from dirt and remnants of the old material.
Measure and cut the new insulation to the required length.
Install the new insulation, tightly wrapping it around the pipeline.
Secure the insulation with special tape or fasteners.

The replacement process typically takes from 30 minutes to 1 hour, depending on the complexity of access to the pipelines.