«Payment by installments» of monobank
payments
of $0.67
No commission. The customer`s billing phone number must match the monobank customer`s financial number
Motor filter (micro) for Bosch and Siemens vacuum cleaners
Motor filter (micro) is designed to protect the vacuum cleaner's motor from fine dust particles. It is compatible with Bosch models 00618907, 00095771, 00187621, 00187622, 00265419, 00578863 and Siemens VZ01MSF. This washable mesh filter provides optimal filtration, significantly extending the lifespan of your vacuum cleaner.
Specifications and compatibility
| Manufacturer | Model |
|---|---|
| Bosch | BSA***, BSA2***, BSA3***, BSA5***, BSD***, BSD2***, BSD3***, BSG4***, BSG6***, BSG7***, BSG8***, BSGL2***, BSGL4***, BSGLS***, BSGMOVE*** |
| Siemens | VS04***, VS06***, VS07***, VS08***, VSZ3***, VSZ4***, VSZ5***, VSZ6*** |
How to choose the right filter
When selecting a motor filter for your vacuum cleaner, consider the following points:
- Compatibility: Ensure that the filter is suitable for your vacuum model by checking the list of compatible models.
- Filter type: Make sure to choose a washable filter if you want to avoid frequent replacements.
- Filter condition: Regularly check the filter for dirt and damage.
Causes of failure and prevention methods
The motor filter may fail for the following reasons:
- Dirt accumulation: Buildup of dust can lead to reduced filter efficiency and motor overheating.
- Obsolescence: Without timely replacement, the filter loses its effectiveness.
To avoid rapid wear, it is recommended to:
- Replace the filter at least once a year.
- Regularly clean the filter of dust and debris.
- Store the vacuum cleaner in a clean, dry place.
Difficulty of filter replacement
Replacing the motor filter in a vacuum cleaner is a relatively simple procedure and can be done independently. Here are the steps for replacement:
- Turn off the vacuum cleaner and disconnect it from the power supply.
- Open the vacuum cleaner casing according to the manufacturer's instructions.
- Remove the old filter by carefully pulling it out of its mounting place.
- Install the new filter, ensuring it is securely in place.
- Close the vacuum cleaner casing and reconnect it to the power supply.
Difficulty of replacement: low. Required tools: screwdriver (if needed). Be careful to avoid damaging other components of the vacuum cleaner.
