«Payment by installments» of monobank
payments
of $3.67
No commission. The customer`s billing phone number must match the monobank customer`s financial number
Pre-motor filter compatible with Dyson DC40 and Dyson DC42 vacuum cleaners is designed to be installed before the motor, preventing dust and debris from entering the engine. This is an important component of the filtration system that helps extend the lifespan of the appliance and ensures stable suction power.
The filter is made of microfiber material and can be easily cleaned under running water. It is recommended to clean it every 1–3 months depending on usage intensity.
| Key specifications | |
|---|---|
| Type | Pre-motor (pre-filter) |
| Purpose | For Dyson vacuum cleaners |
| Compatibility | Dyson DC40, Dyson DC42 |
| Seat size (±1 mm) | 214×53 mm |
| Overall size (±1 mm) | 217×61 mm |
| Material | Microfiber |
| Package contents | Filter — 1 pc. |
| Manufacturing | China |
Reasons for pre-motor filter failure:
- Infrequent cleaning of the filter (clogging reduces suction and puts strain on the motor)
- Mechanical damage (tears, deformation)
- Operation in high dust load conditions
Compatibility
Suitable for the following vacuum cleaner models:
| Model |
|---|
| Dyson DC40 |
| Dyson DC42 |
For quick searching of your model, use the keyboard shortcut Ctrl+F.
Replacement difficulty: Low
Installation instructions:
- Disconnect the vacuum cleaner from the power supply.
- Open the filter compartment located on the top of the body.
- Remove the old filter and install the new one in the same position.
- Close the filter cover and ensure it fits snugly.
- If necessary, rinse the filter under running water and allow it to dry completely before reinstalling.
Attention! Do not use the vacuum cleaner with a wet filter — this may damage the motor.
