|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Oven door seal for Smeg (754131883)
The oven door seal is an essential component that ensures the airtightness of the device's interior chamber. It prevents heat loss, helping to maintain a stable temperature during cooking. Made from heat-resistant rubber, this seal can withstand temperatures up to +315 °C, ensuring its durability and reliability in use.
Technical specifications:
- Material: Heat-resistant rubber
- Size: 450 mm (width) x 330 mm (height)
- Number of hooks: 4
- Profile width: 10 mm
- Profile height: 11 mm
- Hook length: 8 mm
Compatibility:
This seal is suitable for various Smeg oven models. To find the required model, use the Ctrl+F key combination.
| Brand | Models |
|---|---|
| Smeg | ALFA42AMB, ALFA43, ALFA43B, ALFA43DA, ALFA43F, ALFA43GH, ALFA43GHK, ALFA43GHKSA, ALFA43GHU, ALFA43K, ALFA43KSA, ALFA43MF, ALFA43N, ALFA43S, ALFA43SAM, ALFA43SG, ALFA43ST, ALFA43STP, ALFA43T, ALFA43TM, ALFA43UK, ALFA43X, ALFA43XE, ALFA43XEH, ALFA43XEHPL, ALFA43XMF, ALFA43XT, ALFA43XUK, ALFA44, ALFA45GH, ALFA45MFPGN, ALFA45UK, RFF43, RFF43D, RFF43X, SPS43, SPS43GHK, SPS43K, SPS43XE |
How to choose the right seal?
When selecting an oven door seal, pay attention to the following parameters:
- Seal dimensions: ensure that the width and height match your requirements.
- Number of hooks: check that it corresponds to your oven model.
- Material: choose heat-resistant rubber to avoid rapid wear.
Causes of failure and prevention methods
The door seal may fail for several reasons:
- Mechanical damage (impacts, cuts).
- Improper installation, which can lead to incomplete sealing.
- Incompatibility with the oven model, which may cause incorrect attachment of the seal.
- Violation of operating conditions, such as excessive temperature or chemical exposure.
To prevent wear, regularly check the seal for damage and replace it at the first signs of wear.
Difficulty of seal replacement
Replacing the oven door seal for Smeg is a relatively simple procedure that can be done independently. Here are the steps for replacement:
- Disconnect the oven from the power supply for safety.
- Remove the old seal by carefully detaching it from the hooks.
- Clean the surface of any remnants of the old seal and dirt.
- Install the new seal, evenly distributing it around the perimeter of the door and securing it with the hooks.
- Check the door's airtightness by closing it and ensuring there are no gaps.
Difficulty rating: low. The process can be completed independently without special tools.