|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Original microwave plate for LG D=292 mm (MJS63771901)
The microwave plate for LG with a diameter of 292 mm (part number: MJS63771901) is an original replacement part designed to replace damaged or worn components in LG microwave ovens. This plate ensures even heat distribution, allowing for efficient reheating and cooking of food. Its quality construction guarantees durability and reliability in use.
Technical specifications and compatibility
| Parameter | Value |
|---|---|
| Plate diameter | 292 mm |
| Compatibility with models | MB63R35GIB, MB63R35GIH, MB63W35GIB, MB63W35GIH, MB65R95CIR, MB65R95DIS, MB65R95GIH, MB65W65DIR, MB65W95DIS, MB65W95GIH, MH6336GIB, MH6336GISW, MH63M38GISW, MH6565CIR, MH6565DIS, MH6595CIS, MH6595GIH, MJ3965AIS, MJ3965BIH, MJ3965BIS, MS2336GIB, MS2336GIH, MS23M38GIB, MS23M38GIH, MS2535GIS, MS2595CIS, MS2595DIR, MS2595DIS, MS2595FISW, MS2595GIH, MS2595GIS, MW23D35GIH, MW23R35GIB, MW23R35GIH, MW23W35GIB, MW25R35GIH, MW25R35GIS, MW25R35GISW, MW25R95CIS, MW25R95FIS, MW25R95GIR, MW25W35GIH, MW25W35GIS, MW25W95DIH |
How to choose the right part
When selecting a microwave plate, pay attention to the following parameters:
- Diameter: Ensure that the plate diameter meets your requirements (292 mm).
- Model compatibility: Check that your microwave model is listed among the compatible models.
- Originality: Choose original parts to guarantee quality and reliability.
Possible causes of failure and prevention methods
The microwave plate may fail for the following reasons:
- Mechanical damage: Impacts and falls can lead to cracks or chips.
- Overheating: Prolonged use at high temperatures can damage the material.
- Improper use: Using cookware not intended for microwaves can cause damage.
To prevent wear, follow these recommendations:
- Avoid impacts and falls.
- Do not overheat food and adhere to recommended operating modes.
- Use only cookware designed for microwave ovens.
Difficulty of part replacement
Replacing the plate in a microwave oven is a simple task that can be done by yourself. You will need to:
- Remove the old plate by simply lifting it up.
- Check if the rotating disk under the plate is clean.
- Install the new plate on the disk, ensuring it is properly secured.
This procedure does not require special skills and can be completed in just a few minutes.