|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Speed control board for Kenwood kitchen mixer (KW706666)
The Kenwood speed control board (KW706666) is designed to manage the speed of Kenwood kitchen mixers. This part provides precise speed regulation, allowing you to adapt the device's operation for specific tasks such as chopping, mixing, and whipping. This component is essential for maintaining the efficient performance of your kitchen mixer.
Specifications and compatibility
| Model | Compatibility |
|---|---|
| KM280BK | Compatible |
| KM280RD | Compatible |
| KM242 | Compatible |
| KM261 | Compatible |
| KM262 | Compatible |
| KM263 | Compatible |
| KM240 | Compatible |
| KM241 | Compatible |
| KM243 | Compatible |
| KM244 | Compatible |
| KM245 | Compatible |
| KM248 | Compatible |
| KM264 | Compatible |
| KM265 | Compatible |
| KM266 | Compatible |
| KM280 | Compatible |
| KM281 | Compatible |
| KM282 | Compatible |
| KM283 | Compatible |
| KM285 | Compatible |
| KM286 | Compatible |
| KM287 | Compatible |
| KM288 | Compatible |
| KM289 | Compatible |
| MX260 | Compatible |
How to choose the right product
When selecting the speed control board, ensure that the part number KW706666 matches your Kenwood kitchen mixer. Also, check that your model is listed as compatible. If you have any doubts, it is recommended to refer to the user manual or consult a specialist. Be sure to inspect the condition of your current board for any visible damage.
Causes of failure and prevention methods
The main causes of speed control board failure may include:
- Overheating due to prolonged operation at high speeds.
- Moisture ingress into the electronics.
- Component wear over time.
To prevent wear, it is recommended to:
- Avoid overloading the mixer; pay attention to maximum loads.
- Regularly clean the device of food residues and moisture.
- Use the kitchen mixer according to the instructions.
Difficulty of part replacement
Replacing the speed control board is a moderately challenging task. You will need basic tools such as a screwdriver and pliers. The replacement process includes the following steps:
- Disconnect the device from the power supply.
- Remove the mixer casing by unscrewing the necessary screws.
- Disconnect the old board from the wires and mounts.
- Install the new board by following the reverse order.
- Check the connections and reassemble the casing.
With basic electronics skills, the replacement will not take much time and can be done independently.