|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Control board for Bosch kitchen machine 00629487, 00653177
The control module (board) for Bosch and Siemens kitchen machines with part numbers 00629487 and 00653177 is designed for effective management of your device's operation. This control board is responsible for processing commands, controlling speed and operating modes, as well as providing protection against overheating and other malfunctions. By replacing a faulty board, you can once again enjoy all the functions of your kitchen machine.
Technical specifications and compatibility
| Part number | Compatible models |
|---|---|
| 00629487 | MUM54230/01, MUM54230AU/01, MUM54240/01, MUM54251/01, MUM54420/01, MUM54520/01, MUM54530AU/01, MUM54620/01, MUM54630AU/01, MUM54Q40/01, MUM54W41/01, MUM56320CH/01, MUM56320CH/02, MUM56340/01, MUM56340/02, MUM56340AU/01, MUM56S40/01, MUM57810/01, MUM57830/01, MUM57830GB/01, MUM57860/01, MUM59340GB/02, MUM59343/02, MUM59363/02 |
How to choose the right product
When selecting a control board, ensure it matches your kitchen machine model. Pay attention to part numbers 00629487 and 00653177, as well as compatibility with the models listed above. If you are unsure, refer to your device's documentation or consult with a seller.
Possible causes of malfunction and prevention methods
Malfunctions of the control board can occur for several reasons, including:
- Overheating due to prolonged operation without breaks.
- Component wear caused by frequent on and off cycles.
- Moisture entering the device, which can lead to short circuits.
To prevent wear on the control board, follow these recommendations:
- Do not overload the machine; adhere to the maximum operating time guidelines.
- Regularly clean the device of food residues and moisture.
- Store the machine in a dry place, protected from moisture.
Difficulty of part replacement
Replacing the control board is of medium difficulty. You will need the following tools to perform the replacement:
- Screwdriver (usually Phillips).
- Pliers (if necessary).
Steps for replacement:
- Disconnect the kitchen machine from the power supply.
- Remove the device casing by unscrewing all necessary screws.
- Disconnect the old control board by carefully unscrewing the connectors.
- Install the new board by reconnecting all the connectors.
- Close the casing and secure all screws.
- Reconnect the device to the power supply and check its operation.
If you lack experience in repairing appliances, it is recommended to consult a professional to carry out this procedure.