|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Control board for 18V Rowenta cordless vacuum cleaner (RS-RH5673)
The control board is an essential component of the cordless vacuum cleaner, ensuring its functionality and efficiency. This board is designed for Rowenta and Tefal models operating at 18V. Replacing the control board will help restore the operation of your vacuum cleaner if it does not turn on or operates incorrectly.
Technical specifications and compatibility
| Parameter | Value |
|---|---|
| Voltage | 18V |
| Compatible models | Rowenta: RH8812WH/9A2, RH8812WH/9A0, RH8812WH/2D2, RH8819WH/2D0, RH8819WH/9A2, RH8813WH/9A0, RH8813WH/9A2, RH8813WH/2D2, RH8819WH/9A0, RH8819WH/2D2 Tefal: TY8812RH/9A0, TY8812RH/2D2, TY8812RH/9A2, TY8813RH/9A2, TY8818RH/2D2, TY8813RH/2D2, TY8813RH/9A0 |
How to choose the right part
When selecting a control board, pay attention to the following points:
- Ensure that the voltage of the board matches 18V to avoid damaging the device.
- Check compatibility with your vacuum cleaner model using the list of compatible models.
- Inspect the appearance and condition of the board if you are purchasing a used part.
Possible causes of failure and prevention methods
The control board can fail for several reasons:
- Overheating due to prolonged operation at maximum power.
- Moisture exposure, which can cause a short circuit.
- Component wear due to aging and regular use.
To prevent issues with the control board, it is recommended to:
- Avoid overloading the vacuum cleaner and allow it to rest after prolonged use.
- Store the device in a dry place, protected from moisture.
- Regularly clean the vacuum cleaner of dust and dirt to improve cooling.
Difficulty of part replacement
Replacing the control board is a moderately complex task and may require basic knowledge of disassembling electrical devices. It is recommended to follow this step-by-step process:
- Disconnect the vacuum cleaner from the power source and remove the battery.
- Remove the vacuum cleaner casing by carefully unscrewing the screws.
- Disconnect the old control board, remembering the order of the wire connections.
- Install the new board, connecting the wires in the same order.
- Reassemble the vacuum cleaner casing and install the battery.
If you lack repair experience, it is advisable to consult a professional for the replacement.