|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Ulka Type HF 22 W Vibrating Pump
The Ulka Type HF vibrating pump is a high-quality device designed to provide reliable and stable water supply in various household appliances, such as coffee machines and water systems. This pump delivers optimal pressure and flow rate, making it an ideal choice for replacing old or faulty pumps.
Technical specifications
| Parameter | Value |
|---|---|
| Power | 22 W |
| Voltage and frequency | ~230 V, 50 Hz |
| Connection | 2 terminals 4.8 mm |
| Maximum operating pressure | 2.2 bar |
| Flow rate | 680 cm³/min |
| Pump dimensions | 97x38x41 mm |
| Outlet diameter | outer 10/6.6 mm |
| Inlet fitting diameter | outer 6.6 mm |
| Information on the housing | 010515 Model HF, 230V 50Hz 22W, 2/1min. Cl 155 Tf 35°C, VDE-REG E339 |
How to choose the right product
When selecting the Ulka Type HF vibrating pump, pay attention to the following characteristics:
- Power and voltage: Ensure that the pump meets the requirements of your device (22 W, ~230 V).
- Dimensions and connections: Check the pump dimensions and connection parameters for your equipment.
- Maximum operating pressure: Make sure the pump can provide the necessary pressure for your application.
Possible causes of failure and prevention methods
Failures in vibrating pumps can occur for several reasons:
- Seal wear: Regularly check and replace seals to prevent leaks.
- Clogging: Keep the inlet filters and tubes clean to avoid blockages.
- Overheating: Ensure that the pump does not run without load for extended periods, as this can lead to overheating and failure.
Difficulty of part replacement
Replacing the Ulka Type HF vibrating pump is considered to be of medium difficulty. To perform the replacement, follow these steps:
- Disconnect the device from the power supply.
- Remove the old pump by disconnecting all connections and fastenings.
- Install the new pump by connecting it to the same system.
- Check all connections for tightness and proper installation.
- Reconnect the device to the power supply and test the pump operation.
When performing the replacement, follow the manufacturer's instructions and use protective equipment to prevent injuries.