|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
1.5 kW heating element for Thermex ERS/ESS boiler (22)
Description: The 1.5 kW heating element is designed for Thermex water heaters and other brands such as Ariston. This element is made of copper, ensuring high thermal conductivity and durability. It is intended to replace a faulty heating element and provides efficient water heating in the boiler.
Technical specifications:
| Specification | Value |
|---|---|
| Power | 1500W |
| Voltage | 220V |
| Heating element material | Copper |
| Number of sensor tubes | 1 |
| Type of contacts | 2 terminals by connector |
Compatibility:
Compatible with water heaters of the following brands:
- Thermex
- Ariston
- Other brands with similar specifications
How to choose the right heating element:
When selecting a heating element, pay attention to the following points:
- Power: Ensure that the power of the heating element matches the requirements of your water heater.
- Voltage: Check that the voltage of the heater matches that of your device.
- Material: Copper provides better thermal conductivity than other materials such as stainless steel.
- Number of sensor tubes: Ensure that the number of tubes matches your old element.
- Type of contacts: Verify that the type of contacts is compatible with your water heater.
Causes of heating element failure:
- Scale buildup due to hard water.
- Overheating of the element due to low water levels.
- Electrical failures or short circuits.
Methods to prevent failure:
To extend the lifespan of the heating element, it is recommended to:
- Regularly clean the boiler from scale.
- Ensure that the water level in the tank is always sufficient for operation.
- Use voltage stabilizers to protect against electrical failures.
Replacement recommendations for the heating element:
- Disconnect the boiler from the power supply.
- Drain the water from the boiler.
- Remove the cover to access the heating element.
- Disconnect the wires from the old heating element.
- Unscrew the old heating element.
- Install the new element, screw it in, and reconnect the wires.
- Close the cover and refill the boiler with water.
- Reconnect the boiler to the power supply and check the operation of the heating element.
Difficulty level of replacement:
Replacing the heating element has a medium level of difficulty. Basic skills in working with electrical appliances are recommended, and following the instructions for safe replacement is advised.