|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Motor bushing set (front + rear, 2 pcs.) for Electrolux dryer (4055496147)
Description: The motor bushing set is designed for use in Electrolux dryers, as well as models from other brands such as Zanussi and Faure. These bushings provide reliable mounting and support for the motor, contributing to the efficient operation of the appliance. Installing this set will help extend the lifespan of your dryer and improve drying quality.
Technical specifications and compatibility
| Model | Code |
|---|---|
| LSK170 Faure | 916092501 |
| TC7102W Zanussi-Electrolux | 916092502 |
| TC7114W Zanussi-Electrolux | 916092503 |
| PE110M Zoppas | 916092509 |
This set is compatible with a wide range of dryer models, including but not limited to those listed above. Be sure to check compatibility with your model before purchasing.
How to choose the right product
When selecting motor bushings, pay attention to the following points:
- Ensure that the part code (4055496147) matches the original number of your part.
- Check compatibility with your dryer model using the compatibility table.
- Examine the condition of the old bushings: if they are worn or cracked, this may indicate the need for replacement.
Possible causes of failure and prevention methods
Motor bushings may fail for the following reasons:
- Wear due to prolonged use.
- Improper installation, which can lead to additional stress.
- Lack of lubrication or contamination that hinders normal operation.
To prevent premature wear, follow these recommendations:
- Regularly check the condition of the bushings and replace them if necessary.
- Follow the operating instructions for the dryer.
- Keep the inside of the appliance clean by removing dust and dirt.
Difficulty of replacement
Replacing the motor bushings is a moderately difficult task that most users with basic tool skills can perform. To replace them, follow these step-by-step instructions:
- Disconnect the dryer from the power supply.
- Remove the front panel or rear cover, depending on your model's design.
- Remove the old bushings by carefully pulling them out of their sockets.
- Install the new bushings in place, ensuring they are securely fastened.
- Reassemble the appliance and reconnect it to the power supply.
By following these steps, you can replace the bushings without much difficulty.