|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Spray nozzle set for Zelmer cleaning brush (619.0025+619.0039) (12000903)
The spray nozzle set for Zelmer vacuum cleaners, part number 12000903, includes two nozzles (619.0025 and 619.0039). These nozzles are designed for use with cleaning brushes and provide effective spraying of water and detergent, allowing for thorough cleaning of various surfaces. Replacing the nozzles will help restore the efficiency of your vacuum cleaner and improve cleaning results.
Technical specifications and compatibility
| Part number | Quantity |
|---|---|
| 619.0025 | 1 pc. |
| 619.0039 | 1 pc. |
Compatibility:
- ZELMER ZVC780XWRU (619.5.D4S)
- ZELMER ZVC780YW (619.5EW)
- ZELMER ZVC780YWRU (619.5.D4E)
- ZELMER ZVC780ZW (619.5SV)
- ZELMER ZVC780ZWRU (619.5EW)
- ZELMER ZVC782XW (616.6EU)
- ZELMER ZVC782XWRU (616.6EU)
How to choose the right product
When selecting nozzles for your Zelmer vacuum cleaner, consider the following points:
- Check if the nozzles are compatible with your vacuum model. Compare the model numbers with those listed in the compatibility section.
- Ensure that part numbers 619.0025 and 619.0039 meet your requirements.
- Inspect the condition of the existing nozzles: if they are damaged or clogged, this may affect cleaning efficiency.
Possible causes of malfunction and prevention methods
Nozzles can fail for several reasons:
- Clogging: Residues of dirt and detergent can block the nozzles. Clean them regularly after use.
- Mechanical damage: Impacts and drops can cause cracks and breakage. Handle the device carefully.
- Material wear: Over time, rubber and plastic may lose their properties. Regularly check the condition of the nozzles and replace them as needed.
Difficulty of part replacement
Replacing the nozzles is a relatively simple task that can be done independently. Here is a step-by-step guide:
- Disconnect the vacuum cleaner from the power supply for safety.
- Remove the old nozzles by gently pulling them off.
- Ensure the installation area is clean, removing any possible debris.
- Install the new nozzles by pressing until they click into place.
- Reconnect the vacuum cleaner and check the operation of the new nozzles.
Difficulty rating: low. The replacement takes just a few minutes and does not require special skills.