|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
Water pressure sensor 0.5–1.2 bar for Ariston Genus, Genus Premium, Evo boilers
The water pressure sensor is an essential device that monitors the pressure level in heating systems and boilers. Its primary function is to prevent the boiler from starting when the water pressure is insufficient, eliminating the risk of operation without a heat transfer fluid and protecting the equipment from potential damage. This sensor is a compatible replacement for the original part number 65104321 and is suitable for various models of Ariston boilers.
Specifications:
- Device type: Water pressure sensor (relay)
- Operating range: 0.5–1.2 bar
- Connection: For bracket installation in heating pipes
- Compatible replacement part number: 65104321
Compatibility with models:
This sensor is designed for installation in the following models of Ariston gas boilers:
- Ariston Evo 24-30-35 CF/FF
- Ariston Genus 24-28-35-36 CF/FF
- Ariston Genus Premium 24-30-35
- Ariston Genus Premium Evo 24-30-35
- Ariston Genus Premium Evo System 24-30-35
How to choose the right water pressure sensor:
When selecting a water pressure sensor, pay attention to the following points:
- Ensure that the operating pressure range (0.5–1.2 bar) meets the requirements of your heating system.
- Check compatibility with your boiler using the model list above.
- Consider the quality and materials used to reduce the risk of rapid wear.
Reasons for sensor failure and prevention methods:
The water pressure sensor may fail for the following reasons:
- Wear due to prolonged use.
- Scale buildup that can block the sensor's operation.
- Exposure to high temperatures or mechanical damage.
To prevent breakdowns, it is recommended to:
- Regularly check and clean the heating system from scale.
- Monitor the condition and operation of the boiler by conducting preventive inspections.
Difficulty of sensor replacement:
Replacing the water pressure sensor does not require special skills and can be done independently. The level of difficulty is low. Recommended steps:
- Disconnect the boiler from electricity and shut off the water supply.
- Remove the old sensor by carefully disconnecting it from the pipes.
- Install the new sensor according to the instructions.
- Reconnect all connections and check for leaks.
- Start the boiler and check the operation of the new sensor.
By following these recommendations, you can ensure the reliable operation of your heating system and avoid potential failures in the future.